Nozzle Centre

By activating this program, you can check the center point of the nozzle where the beam is generated. To perform this check, apply some grease to the nozzle tip and cover it with white tape. When you run the program, the beam will be generated using the specified parameters at the defined position. After that, remove the white tape and verify whether the beam spot is at the center of the nozzle tip ring.

With the above entries, X and Y axis moves towards the positioned value.

Running the program will follow the data of power, frequency and duty as per the user requirement.

Focus diameter, Focus distance and dwell time also has been modified according to the user requirements. Entered values can be monitored when the program runs. The specified Dwell time will hold the program and then abord the program..