Check for Bound Program Active
The outer boundary run of the job can be checked for the current work offset, if required the offset can be changed:
The check for activation of Bound program is defined internally as follows:
#globdef CheckBoundPrg G20 X65535 E46
If the Outer Bound program is selected, the Q-bit 46 (E46) will be activated in PLC.
So, when the main program is started, it will jump to Block number N65535 (it is the maximum value) to run the outer bound program.
Syntax: CheckBoundPrg
-
This function will be useful to check the Job will be fit into the sheet
-
For longer jobs, possible to do the marking at the corners with Special parameter